This is the fully customizable SKADIS board, ever wanted to print your own SKADIS Ikea Board but didn’t want to put screws in the wall on every board leaving you with a wall with 20 screws in it for a simple 2×2 board. This board not only allows you to make a board of unlimitedxunlimited but also only requires 4 screws in the corners to hold the board up. Additionally, the model is separated by colors by their various designs, this allows you to fix the specific piece you need to not only make the boards look seamless between each of them but also give the proper edges where they are required/chamfered. For example, if you wanted a 5×5 SKADIS board, you would need to print 25 plates:
1 – Top Left Corner 3 – Top 3 Way 1 – Top Right Corner
3 – Left 3 Way 9 – Center 4 Way 3 – Right 3 Way
1 – Bottom Left Corner 3 – Bottom 3 Way 1 – Bottom Right Corner
You would then assemble them like a book, fitting together with the dove tails the very top row, then putting toghet the very next row all at once and then all at once putting row 2 together with row 1. Repeating until the entire board is together.
If your board is massive such as 8×8 there is a custom Bottom 3 Way called Bottom 3 Way Supported which will allow you to put a screw in the middle of the bottom support to hold the massive 64 panel wall for example.
Lastly, there are 2 other “designs” marked with Red and Blue color, those are used if you are going to have a “thin” board for example Blue would be 1xunlimited:
Top
Middle
Middle
Bottom
And the Red would be unlimitedx1
Left Middle Middle Bottom
Customize to your hearts desire, make the board that looks nice and seamless to your needs.
Credits:
Download 3D models
| File | File size |
|---|---|
SKADIS+Boards
|
3 MB |
|
SKADIS+Boards_stls
|
2 MB |