A rearrange-able display I designed for amiibo figures. Should fit most, if not all, amiibos (not sure about the guardian amiibo).
Print Settings
Printer Brand:
Printrbot
Printer:
Printrbot Plus
Rafts:
No
Supports:
No
Resolution:
2.5 mm
Infill:
18%
Notes:
F.Y.I. I’m not using the play, I’m using an old Printrbot Plus V2. I recommend reducing the travel speed of the printer in the case that the holes on the underside of Display_Top.stl have difficulty adhering to the bed. Average print time on my Printrbot with these settings was ~3.5 hours for one Print_Plate.stl, running at a print speed of 35 mm/sec, with a travel speed of 55 mm/sec.
Credits:
OldVersions