A four part monitor stand meant to hold a 24 in monitor. Monitor Tilt is adjustable. If anyone wants a different height, there is a model attached with different height positions for the Vesa Mount. You need 350mm of print height, and a 300mm^ bed to print the base in one piece. If you use this model please consider donating.
This base was printed with a 0.8mm nozzle, two outer layers, and 0.25mm layer height. Infill was 50% with a triangular pattern.
The bolt and grapel were printed with a 0.4mm nozzle, five outer layers, and 0.2mm layer height. Infill was 70% with a triangular pattern.
The Vesa mount was printed with a 0.4mm nozzle, 3 outer layers, and 0.2mm layer height. Infill was 50% with a triangular pattern.
If you intend to use this part make sure you are using high quality filament, and at minimum, the settings I used about, if not more. With my filament, the stand was able to hold 20lbs for 15 minutes without a problem.
Credits:
SooperKewlDesigns