                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2467027
Pokemon Go Plus Ring by margiemakerspot is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

This is an add-on for your Pokemon Go Plus that you can use to wear it like a ring. I like wearing it on the inside of my hand for easy access to the button on the Go Plus while I'm walking. The interior diameter of the ring is 20mm.

# Print Settings

Printer: PolyPrinter 229
Rafts: Yes
Supports: Yes
Resolution: 0.125
Infill: 12.5

Notes: 
I printed it upright like the file shows, and the scaffolding was very easy to remove. If you can't do rafts, it's probably fine, but I wanted to make sure it stayed very straight. I printed this in ABS.

# Post-Printing

![Alt text](https://cdn.thingiverse.com/assets/a9/91/d2/ab/3a/2017-08-03_16.04.35.jpg)
Printed Part

![Alt text](https://cdn.thingiverse.com/assets/4e/3e/07/f8/31/2017-08-03_16.05.51.jpg)
Wearing it on the inside of my hand

![Alt text](https://cdn.thingiverse.com/assets/43/5d/38/d7/96/2017-08-03_16.04.55.jpg)

# How I Designed This

I designed this based on the mount found here: https://www.thingiverse.com/thing:1877478, and used TinkerCad to add a ring that is the correct size for my finger.