                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2477160
Oculus touch - Gun Stock streamlined by Davehaslanded is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

This is a streamlined remix of the Oculus gun stock by Gurgelx. It has been adjusted to be Easier to handle, use less filament and be put together entirely without extra hardware or glue. All parts ave been friction welded together and cleaned up in post processing. I have even made pins which can be printed to allow the rail mounts to be adjusted. i have also included an optional, shorter stock.

The reinforcement brackets are designed to slide onto the bottom rail and, well, reinforce the joints. These are however optional.

You need to print
2 x Rail Body.stl (rails)
1 x Rail End.stl (end of rail)
2 x touch rail adapter (rail mounts)
1 x Stock clip (stock mount)
1 x touch-stock-mk2.stl or MK2
1 x touch-mount-left-mk3.stl
1 x touch-mount-right-mk3.stl
2 x pin.stl

construction is self explanatory., But message or comment for help.


# Print Settings

Printer Brand: FlashForge
Printer: Finder
Rafts: No
Supports: Yes
Resolution: 0.18
Infill: 10%

Notes: 
4x perimeter with 0.4mm extruder

# Post-Printing

## All parts friction welded together

No glue needed. Dremel used to friction weld parts together where needed

## Sanding

Mainly sanding down welding so leave a smoother finish

## Painting

I ran out of grey filament and had to switch to blue. Black looks better.