                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2900835
Lens Cover and Controller Holder for Oculus Go by Chimaera is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

Lenses on VR equipment are very sensitive to sunlight, and the Oculus Go headset does not come with a cover or case so I designed a fitted protector for the lenses and also incorporated a holder for the controller.  Designed in 2 pieces so it can be printed flat, the controller holder snaps into the hole and is rotatable, it's a little tight but it will fit and I didn't want it to freely rotate.  

There is a 2nd version of the cover without the logo and the controller hole moved to the center, in case you would prefer that one.  

# Print Settings

Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 Plus
Rafts: No
Supports: Yes
Resolution: .3mm
Infill: 5%

Notes: 
Supports on the controller holder depending on orientation, no supports needed for the protector itself if printed face down (nose piece up).   Printed with Ziro Marble 1.75mm PLA.