                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2357789
USB Charging Stand by walter is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

Multi-device USB charging stand.  Holds up to 6 devices, each up to 1cm thick, and fits over an [Anker 10 port USB charger*](http://amzn.to/2qIN6HU).  The stand flexes to clip over the charger from above (you can't slide it in from the front because the charger is thicker in back and you can't slide it in from the back because there's some beams to keep the charger aligned with the front of the stand).

Atomic Filament Clearance [Ruby Red Translucent PLA](https://atomicfilament.com/collections/opaque-pla-filaments-1/products/gemstone-ruby-red-translucent-pla).

**affiliate link*

# Print Settings

Printer: Eustathios
Rafts: No
Supports: No
Resolution: 125 micron

Notes: 
2 perimeters, 0.5mm extrusion width