                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2412007
HTC Vive Desk Stand by Marcos10Soares is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

HTC Vive desk stand including controller and it is possible to charge the controllers while on the stand.

Weights aprox. 350g and it is very stable, the base is 180x180mm and you need aprox 250x250mm of desk space to have this on your desk.

You need:
- 2 M4 or M5 screws
- 2 washers (i used 4 to get some height because I had long screws)

This is a remix created from this PSVR Stand:
https://www.thingiverse.com/thing:1978075

Plus the dual htc vive wand charging stand:
https://www.thingiverse.com/thing:1540715

# Print Settings

Rafts: No
Supports: Yes
Resolution: 0.2
Infill: 25%

Notes: 
This was 3d printed with HDGlass from Form Futura, which is very similar to PETG.

Printed with 0.2mm layer height and 25% infill.

Put manual supports inside the handles, view last image for referral, no need for support anywhere else.