                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:2296540
Nintendo Switcherang by MikeSalt is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

This is a travel controller for the Nintendo Switch.  The Joycons just friction fit into the slots on the sides and it's good to go!  Very comfortable to use and helps with the reach from the right thumbstick to the ABXY buttons.

Full article on the project is [here](http://www.saltfabs.com/2017/05/04/switcherang-nintendo-switch-travel-controller/) and you can follow along with my 3D printing shenanigans at https://www.saltfabs.com

E: May 7th 2017; fixed some naked edges in the original model

# Print Settings

Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 V2
Rafts: Yes
Supports: Yes
Resolution: 20 microns
Infill: 15%

Notes: 
A little rough around the edges on quick print settings, but easily cleaned up.