                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:2112212
GoPro Session Protector / Cover with Strap Slots by Airmaxx23 is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

I really like the protection that this Session (Session 5) case offers but would like it even more if it had slots for a strap so I added them to it.  This is a very tight fitting case and should only be printed in flexible filament with a 60-100% infill.  Supports are not needed when it is printed with the back of the case on the print bed like it is shown in the rendering.

Don't be afraid to stretch the opening so the camera will go in easier.

The case can not be seen in recorded video, even in SuperView.

May 03, 2017:  Added another version with a slightly larger opening which makes inserting and removing the Session a little easier.  

# Print Settings

Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 V2
Rafts: No
Supports: No
Resolution: .25mm
Infill: 60-100%

Notes: 
This can be printed without supports.