                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1803794
Smart Phone Wall Mount by 3ddruckqueck is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

A fully 3D printed articulated wall mount for your smart phone. 

Chose the Phone_Bracket file which corresponds the best with your total width (including any hull etc.)

I'm using Phone_Bracket_750 for my LG G4 since it's about 75mm wide.


I don't have the time right now to revise it to be easily customizeable so I included different versions ranging from 65mm up to 80mm of width in 2.5mm step size. 

With the clamping screw it has a adaptability of around 8 mm.


# Print Settings

Printer Brand: MakerBot
Printer: MakerBot Replicator (5th Generation)
Rafts: Doesn't Matter
Supports: No
Resolution: 0.15
Infill: 10%

Notes: 
I suggest 3 perimeters, no support and 20% infill for the wall mount and bolts and 10 % infill for the rest.

You can add supports to the horizontal smooth 10 mm bore holes if you want to, the threads have lots of tolerance and should do fine without, low layer height helps with the overhangs.

# Post-Printing

Assemble as seen in the picture - tighten the bolts to reduce / stiffen the movability.


<iframe src="//www.youtube.com/embed/tF8k6KH-PzY" frameborder="0" allowfullscreen></iframe>

# How I Designed This

Made with OpenSCAD, I'll propably make it customizeable if I get some free time and there is demand for it.

Includes polyScrewThread_r1.scad by aubenc:
http://www.thingiverse.com/thing:8796