                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:1289078
iPhone 6/6s stand by properbowen is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

iPhone 6/6s stand remixed from Shodan's model with the watch stand.

I liked the design of the stand, but am not blessed with an Apple Watch so I had to modify it slightly.

This currently fits an iPhone 6/6s without a case. (I've never used or needed a case myself). However I'm happy to modify and upload any additional variants to fit your case if you can provide the dimensions. Alternatively I've remodelled in SW and uploaded the .sldprt so feel free to adjust it yourself! 

I've also added a tray to the base with the intention of fitting a lump of steel for weight, but may be more useful left open as a tray.

26/01/16, added trial stand for "otterbox" case. Work in progress (WIP). If you want to check for fit without wasting too much material/time, try slicing it 22mm up and print only the top half.

11/05/16, updated "otterbox" version following feedback. Lightning connector seat lowered by 2mm. If this is too much, a small spacer can be used to set the height. 

19/07/16, added version for apple silicone case. <strike>Untested work in progress</strike>. Tested and approved.

06/09/16, Updated version for apple silicone case to add 1mm to connector height; Added [untested] version for Tech20 Sport case.