                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1596815
Hero Stand by exfusion is licensed under the Creative Commons - Attribution - Non-Commercial - No Derivatives license.
http://creativecommons.org/licenses/by-nc-nd/3.0/

# Summary

Update01: (FullStandReadyForPrint02.stl) modified the gap under the left and right feet.

iPhone 6 Stand, Fits iphone 6 without protective case.

# Print Settings

Printer: FlashForge Dreamer
Rafts: No
Supports: Yes
Resolution: 0.1 / 0.2 mm
Infill: 30% - 50%

Notes: 
No restriction on the setting, however, for ultimate results, use at least 30% to 50% infill and a layer height of 0.1 mm or 0.2 mm.

If you have issues with your models sticking to the build plate, then I recommend you add a few columns of support reaching midway on the inclined stand. otherwise, support is already built into the model. 

- Printing Time 05:30 at 0.2 mm layer height and 10:35 at 0.1 mm layer height