                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:2061636
Car back seat tablet mount by pgote is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

This is a remix from http://www.thingiverse.com/thing:1664384 - thank you Shaplov. And the hook origins from http://www.thingiverse.com/thing:128136 - thanks YoungBuck.

In order to get the tablet to stay in place I've added a top module that is to be connected to the bar module using an rubber band. The bar is snapped into place onto the left and right module.

I have also extended the bar length to 160mm (from 140mm) and created an additional 180mm wide bar.

# Print Settings

Printer: Velleman k8200/mk2b heatbed/e3d v6 hotend
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.2mm
Infill: 30%

Notes: 
The weak spot is the hook on the left and right modules if your print does not allow for flexibility and if the headrest rod has a large diameter.

# Post-Printing

![Alt text](https://cdn.thingiverse.com/assets/cc/18/33/7e/f9/IMG_20170127_110940.jpg)
Printed in ABS with 30% rectilinear infill

I did my first with 20% but the hook broke so I increased to 30%. I will also do acetone vapor smoothing to increase the strength a bit more and to get a nicer finish.