                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2451934
GoPro (The Tool) by Jonathan_K1906 is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

I had tried to reconstruct GoPro's "The Tool" in Fusion 360. I tested it and it works just as well as the original tool. I took off the bottle opener because it would difficult to print and may break easily. This is an easy and fast print, takes about 30 minutes to print! I uploaded two version of the model. One model is a "printer friendly" version and the other is closer looking model of the original. 

Printed in Hatchbox Red PLA: https://www.amazon.com/HATCHBOX-3D-PLA-1KG1-75-RED-Filament-Dimensional/dp/B00J0GO8I0/ref=sr_1_1?ie=UTF8&qid=1501210582&sr=8-1&keywords=hatchbox+red+pla

Check out my other GoPro screw tightener here: https://www.thingiverse.com/thing:2454537 

# Print Settings

Printer: Anet A8
Rafts: No
Supports: No
Resolution: 0.15 - 0.2
Infill: 25% - 100%

Notes: 
I used 25% infill which works fine.