                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2469915
Notebook Webcam Cover by gmlupatelli is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

This is a small notebook`s webcam privacy cover.

Print it with 0.10mm resolution, since I design it with that in mind, so if you use 0.2mm resolution it may not work.

After printing it you may need to trim the sliding cover sides a bit for a better fit.

To attach it to your notebook use a double sided tape, as shown in the photos. I also use a small piece of tape to hold the sliding cover in place while I install it.


The model is fully customizable and is available at OnShape: https://cad.onshape.com/documents/cfe330ab82ad640262d072aa/w/e5cf67802fab676b6a1fe4de/e/6ecd9a34656cbae44d3c1945

# Print Settings

Printer Brand: Prusa
Printer: Prusa Clone
Rafts: No
Supports: No
Resolution: 0.10mm
Infill: 100%