                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2894352
Y.A.F.H.H. (Yet Another Headphone Holder) by garylovesbeer is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

I was sick of my new Sony WH-1000XM2 sitting on my desk and risking being knocked off so I knocked up this design to clamp to the Ikea benchtop I use as a desk. The benchtop is 38.2mm thick and the headphone band section is 30mm wide.

Printed on some dodgy orange PLA I use for prototyping but it turned out fine.

Printed on edge with supports turned on up to 45º. Only generated a few supports so my not be totally necessary.

Get in touch if you would like the desk thickness altered.

Thingiverse can never have enough headphone holders!

# Print Settings

Printer: Anet A8
Rafts: No
Supports: Doesn't Matter
Resolution: .20mm
Infill: Up to you