                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1917889
Phone GoPro clamp / head mount (customizable) by ppet36 is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

Simple customizable mount for phone for use as standard GoPro accessory. It's inspired by many things here.

Default parameters are suitable for iPhone 6 with cover.

Main motivation to create this thing is need to have both hands free while filming via iPhone. With two GoPro/rod adapters created with Mooncactus GoPro thing (http://www.thingiverse.com/thing:62800), bended threaded rod and GoPro strap mount i created iPhone head mount, as you can see on picture. 

# Print Settings

Printer Brand: RepRap
Printer: Prusa i3 plus
Rafts: No
Supports: Yes
Resolution: 0.2
Infill: 50%

Notes: 
Printed from PLA with supports from 30° slope. 

# Post-Printing

## Assembly

You need some spring or rubber band to make this thing work. Also some thin wire, needle or pin to lock the spring or rubber band in place.

After printing, it is necessary to remove the thin wall on the upper part with GoPro connector with brakable knife. The wall is here only to avoid generating supports inside the element.