                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2956836
Monitor Stand by SooperKewlDesigns is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

A four part monitor stand meant to hold a 24 in monitor. Monitor Tilt is adjustable. If anyone wants a different height, there is a model attached with different height positions for the Vesa Mount. You need 350mm of print height, and a 300mm^ bed to print the base in one piece. If you use this model please consider donating.

This base was printed with a 0.8mm nozzle, two outer layers, and 0.25mm layer height. Infill was 50% with a triangular pattern.

The bolt  and grapel were printed with a 0.4mm nozzle, five outer layers, and 0.2mm layer height. Infill was 70% with a triangular pattern.

The Vesa mount was printed with a 0.4mm nozzle, 3 outer layers, and 0.2mm layer height. Infill was 50% with a triangular pattern.

 If you intend to use this part make sure you are using high quality filament, and at minimum, the settings I used about, if not more. With my filament, the stand was able to hold 20lbs for 15 minutes without a problem.