                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1404846
Phone Camera Stand by pacific_motion is licensed under the Creative Commons - Attribution - Share Alike license.
http://creativecommons.org/licenses/by-sa/3.0/

# Summary

Here is my phone camera stand. 

The stand is made so it enables rotation in two direction. Only non printable parts are 16mm M3 screw with nut  and rubber band. 

I used PLA. 
The Part 1 (the base) was printed at 70mm/s 15% infill 0.2 resolution and 3 perimeters (0.4). I used support but i'm sure it can be done with out it as well. It came out very rigid.
 About other parts.
Other parts were printed at 30% infill. Smaller parts were printed at slower speeds to get better results.
Part 3 has two versions one si for bigger phones one is for smaller. For most newer phones print the bigger version.
You need part 4 two times. 
I included .ipt fills (inventor files) if somebody wants to fiddle with it. 


The

# Print Settings

Printer Brand: RepRap
Printer: Prusa i3
Rafts: No
Supports: Doesn't Matter
Resolution: 0.2
Infill: base 15%, rest 30%

Notes: 
Support probably not needed but it can result in better print when printing part 1 (base)

# How I Designed This

![Alt text](https://thingiverse-production-new.s3.amazonaws.com/assets/49/fa/9c/39/8b/Phone_camera_stand.JPG)

![Alt text](https://thingiverse-production-new.s3.amazonaws.com/assets/8b/42/c9/b4/73/WP_20160310_11_52_19_Pro_LI.jpg)

![Alt text](https://thingiverse-production-new.s3.amazonaws.com/assets/d3/85/c9/a6/94/WP_20160310_11_51_09_Pro_LI.jpg)