                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3551855
Bottle Cap Keyboard by fmtuve is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

This is a design for a "Bottle Cap Keyboard", a miniature version of The President's Key. 

Although I made this for an Arduino Pro Micro case, it's really a working single-key-board that can be used as a hot-key-board.

Grab any favorite PCO1881 standard bottle cap (most soft drink bottles conform).

I programed it with Cmd+Q(mac) / Alt+F4(pc) for quit from applications but you can change it to any key command.

All design files are licensed as Creative Commons - Attribution - Share-Alike. 
The firmware for the Arduino is licensed under the more permissive MIT license.

# Print Settings

Printer Brand: Prusa
Printer: Prusa Clone
Rafts: No
Supports: No
Resolution: 0.4mm
Infill: 5%
Filament_brand: Any
Filament_color: Coffee
Filament_material: PLA

Notes: 
Layer Height: 0.2mm

# Post-Printing

## Build Instructions

Print out parts and place an Arduino Pro Micro board with pinhead attached.

Insert the switches into the top case and wire them up. (I used pinhead connector)

One pin of switch needs a signal wire to 8(A8), and other pin is connected to ground(GND).

Firmly press the keycaps onto the button stems.

Upload the firmware and enjoy!

![Alt text](https://cdn.thingiverse.com/assets/58/bf/9e/db/00/IMG_20190411_153310.jpg)

<iframe src="//www.youtube.com/embed/AGkbZXVQaqw" frameborder="0" allowfullscreen></iframe>
Detailed build instruction. (ENG SUB)

# You will need

![Alt text](https://cdn.thingiverse.com/assets/b1/9e/c7/88/8a/002.jpg)