                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1280446
Pacman : Pac-Guy USB Stereo Speaker by hkucs-makerlab is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

Pac-guy USB stereo speaker as a demo to show 3D modelling design and prototyping to students, using the same components of http://www.thingiverse.com/thing:1267068
They are 
-- 2 x 40mm 3W speakers  such as http://goo.gl/0C5fYP
-- USB Audio Dongle, this one http://goo.gl/0mIdO9
-- Micro audio amplifier, get it here http://goo.gl/5EiPAM
-- 3.5mm headphone jack
-- wires
The power for micro audio amplifier is from  the USB connector of audio dongle.

demo video - https://youtu.be/ufk-sHNWbp8

Hope you enjoy the making!

# Print Settings

Printer: da vinci 1.0  using opensource firmware
Supports: Yes
Resolution: 0.2mm
Infill: 10

Notes: 
Recommend to print with brim for bot and top parts in addition to using support

# Post-Printing

3D parts are using m2 screw to join.
Use the glue gun to firm the speaker holder to top part and sliding the speakers to them, further tight them with m2 screws.