                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2875499
Ipad Wall Bracket For Holding 12.9" ipads by tswalter is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

I remixed this because I couldn't find one for my 12.9" ipad and needed one. The original design was fine but just didn't fit the new ipads. The bracket works very well as originally designed. I elongated the holes when resizing it which allows for leveling the bracket if your screws are not perfectly plumb. You may want to adjust the height and/or width to fit your particular ipad if not the standard 12.9 current (2017/8) model.

# Print Settings

Printer Brand: Creality
Printer: CR-10S
Rafts: No
Supports: Yes
Resolution: Draft
Infill: 25%

Notes: 
Print a .8 floor and walls for strength and ease in removing print. You need supports for the 4 overhanging components but a small zig-zag works fine.  I only used a 25% infill for rigidity and durability over the long use but a higher level is not necessary.