                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2480796
Modular Surround Speaker by jongdepaul is licensed under the Creative Commons - Attribution - Non-Commercial - No Derivatives license.
http://creativecommons.org/licenses/by-nc-nd/3.0/

# Summary

After having made the Modular Sound Bar / Center Speaker (https://www.thingiverse.com/thing:2446587) I continued my project of making a full set of speakers using my 3D printer. You could already use the modules of the Sound Bar as stereo and surround speakers, but for my situation I needed the speakers to have a little stand. Once I had done that and hooked everything up I found the high frequencies lacking a bit with the speakers I used so I added a tweeter. This is the result, again fully printable without supports. If you compare the sound bar with this unit you will find that I used different speakers - I have ran out of the units I got from China so I used some (more expensive) store bought (JayCar Australia) ones.

As with the sound bar, please let me know how you go if you end up making these. 

# Print Settings

Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 Plus
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 20%

# Post-Printing

You will have to put everything together using small screws. I used the soldering iron to do all the connections. The tweeter has a 6uF bipolar capacitor connected in series

# How I Designed This

Designed using Tinkercad