                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3602519
Monitor camera mount - Tripod screw by BrienAllison is licensed under the Creative Commons - Attribution - Share Alike license.
http://creativecommons.org/licenses/by-sa/3.0/

# Summary

This is a design to mount a camera which uses a standard 1/4-20 UNC thread mount onto a PC monitor (approx 60mm in depth). The mount hooks over the front bezel of the monitor and hangs off the back.

The mount pivots forwards and backwards on a joint using two M4x40 bolts. This is tightened into place using two M4 nuts (ideally nylock nuts) captured in large hand tightening knobs. 

This design also requires a standard 1/4-20 tripod screw e.g. https://www.amazon.com/Smallrig-Threaded-Tripod-Monopod-Release/dp/B00R7AWP04 which also acts to pose the camera to the left and right. 

This was originally designed to mount a SUB2r camera and a special top piece 'CMM Top SUB2r' is included for this particular camera (it has a large hole in the base for the fan).

You will need to print: 1x 'Base', 1x 'Top' or 'Top SUB2r' and 2x 'Knob'. All parts are intended to be printed in their default orientation and the 'base' part requires some support material.

I have also included STEP files of the components and the original Fusion 360 file so you can alter it for your own needs if you wish.

I have not yet printed this design as it was designed for someone else. Let me know if you need any slight changes and I'll try to help as soon as I can.