                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2172882
Nintendo Switch Portable Charging Stand by JPoel is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

Buy it on Etsy!  https://www.etsy.com/listing/505538516/nintendo-switch-portable-folding-stand?ref=shop_home_active_1

Update2:  I tweaked the design a bit so it's taller.  The bottom of the Switch now sits about a half inch higher off the table than before.  This allows more room for the charging plug to prevent strain on the cable.

Update:  I have added a new center piece called Switch Stand Center Foldable.  This piece has two hinges of differing height, which allows you to fold the arms inward.  The center piece is also a bit wider than the original, so the arms can fold completely within the width of the center.

This portable Zelda-themed charging stand is the perfect solution to a common issue with the Nintendo Switch.  This stand features:
-Fold-flat design that fits into the same footprint as the Switch, meaning you can pack it into your travel case with your Switch!
-60 degree angle gives ideal viewing position
-Play your Switch while charging!  Charging cable can be run through the front or out the back of the stand
-Wide base gives it a lot of stability
-Simple three-piece assembly.  The hinge pins are made from 1.75mm filament.  Just cut a piece and slide it through the hinge holes.  Can also be disassembled by sliding the filament back out.

Note:  Cut the hinge pin filament at an angle to help it slide through the hinges.  You will likely need a pair of pliers to feed it through.

# Print Settings

Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 V2
Rafts: Doesn't Matter
Supports: No
Resolution: .2
Infill: 30%

Notes: 
I printed this at 0.2mm layer height and 30% infill.  I recommend a brim so the corners don't lift up during printing.