                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2877748
Pi Eye - Raspberry Camera 2.1 mountable case by TraylorHead is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

A complete new design case for the Raspberry Pi Camera 2.1.

This has a snap together case with ball mount to allow it to be adjust in different angles. The design has a flat mount and a corner mount.

When inserting the ball into the mount, it will be tight. If the mount breaks then try scaling the mount slightly bigger.

I printed mine in fine mode to give the ball a smoother surface to allow better adjusting of the camera.

1. Attach cable to camera
2. Place camera in front cover on alignment pins
3. Install back cover straight down. Use a pair of pliers to open the opposing keeper.

# Print Settings

Printer Brand: PowerSpec
Printer: PowerSpec 3D Pro
Rafts: No
Supports: Yes
Resolution: Fine 0.1
Infill: 80%

Notes: 
Depending on printer model and setting you may need to scale the mounts to get the best fit if it seems loose. You can also use a small piece of tape on the ball to fill the gap.