                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2885706
iPad Pro bed stand by Hvmhvm is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

Stand to hold an iPad Pro while lying in bed on a pillow (in landscape at a 20 degree angle). After I designed and printed the part I discovered it needed to be a bit longer to avoid the iPad falling over (due to the fact that the mattress is not perfectly stiff), so I added a second piece that fits at the bottom of the original piece. It also allowed me to test what the best place was to attach it. You can also take it out and put it back in the other direction when needed on the other side.

# Print Settings

Printer Brand: Ultimaker
Printer: Ultimaker 3
Rafts: No
Supports: No
Resolution: 0.1 mm layer height 
Infill: 40% infill

# How I Designed This

Designed in Onshape ([link to design files](https://cad.onshape.com/documents/eb4de546feaae2b446276d5a/w/271fcac825a8f041a9d3a630/e/3972a7be329ad56447987b64))