                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3625040
Hängare: Headphone holder insertable in an Ikea Kallax corner  by Zeiberstein is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

This headphone hanger differs from other hangers because it can be clamped into a interstice between two adjacent corner elements. Secured without damaging anything.

If your headphone is lightweight, you’ll be fine with only the hanger itself. If your headphone is heavier, insert the vertical support rod to prevent bending (and eventual breaking) of the thin plate.


# Print Settings

Printer: Anycubic I3 Mega
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.2
Filament_brand: cheap
Filament_material: PLA

# Post-Printing

Release the corner elements with a hex key, insert the hanger and fasten them again. 

# Custom Section

## credits

I used the design of the joint from [Mounting elements for IKEA's STUGVIK shower rack](https://www.thingiverse.com/thing:2930027)