                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3599199
Xbox One Thumbstick Extenders by WYseman76 is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

I really liked how well KillStix's extenders held strong to the stock thumbstick compared to many others I tested. I wanted something a bit more gripy for the tops as well as a bit of height variety. 

The top is from oobasnork's extender with 12 small nubs added to give a bit of much needed grip.

There are 3 versions, a Low, Mid, and Tall variant.


# Print Settings

Printer Brand: Creality
Printer: CR-10
Rafts: No
Supports: Yes
Resolution: .2
Infill: 25%
Filament_brand: Hatchbox 
Filament_color: grey
Filament_material: PLA

Notes: 
I'm using zig-zag supports with a slight roof in CURA 4.0

# Post-Printing

I print with the base down and pop out the supports with no problem. This leaves the tops clean with a great griping surface.