                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2846498
PiBoox by Remotheman is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

An Little Volumio BoomBoox for Your spare Rpi Zero W.

# Print Settings

Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 V2
Rafts: No
Supports: Yes
Resolution: 0.15
Infill: 100

Notes: 
Use supports but exclude microsd and screw holes.

# Post-Printing

## Electronic Parts

Parts:

Raspberry Pi Zero W
GPIO header
Some cables
HiFiBerry MiniAmp
2x 3W 8Ohm speakers
MiniHDMI to HDMI adapter
MicroUSB cable(you might need to trim some fat off that plug to get it through the hole)
Nice big button (for shutdown command)
Rotary Encoder EC11 (volume and play/pause)
Knob for encoder - mine is printed
Rubber feets
Bolts (of course) and nuts (M3 or M2, various length)
4x standoffs (same as screws)

Start with mounting speakers, then Rpi and dac. There are 5 cavities for mounting down lid (M3 nuts).

# How I Designed This

Designed in ThinkerCAD