                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1984701
Yet Another Micro SD Card Storage Case by pbeyl is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

Yet another Micro SD card storage case. I tried printing some of the other similar designs but had trouble with tolerances so I redesigned this from scratch in order to improve the fit fr my Samsung Micro SD Cards. This design provides a looser fit for the SD cards.

The case can store up to 16 micro SD cards, a very convenient way to store your camera or drone SD cards securely.

Dimensions: 52x22mm

Should the lid fit too snugly onto the bottom after printing. Fill the cap with a little boiling water, wait for 30 sec pour out the water and patiently screw the cap on and off to ensure a proper fit. Repeat the process if required.

It can also help to reduce the extrusion flow percentage. However none of this should be necessary as I included required tolerances in order to negate any post printing finishing, please let me know your experiences?

I will update the design and re-upload should it be required.

# Print Settings

Printer: Prusa i3
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 20%

Notes: 
Printed in PLA 190/50