Frosty Bones is the perfect solution to get your family off your back about decorating for Christmas too early. This ornament is perfect for the fall and winter season.
The figure is 10.0 cm x 5.6 cm.
I did not do much cleanup, other than remove the supports. I suggest only printing supports attached to the build plate, and printing this at a 90 degree angle (see photos of how I oriented Frosty Bones).
I suggest you print in white, like I did, and then paint on the black and orange.
If you like this or find it useful, please consider leaving a small donation for the time I put into these designs.
Enjoy the holiday season!
Print Settings:
Printer brand: Creality
Printer: Ender-3 S1
Rafts: No
Supports: Yes
Resolution: 0.2 mm
Infill: 20%
Filament brand: ANYCUBIC
Filament color: Bright White
Filament material: PLA
Notes: I did not do much cleanup, other than remove the supports. I suggest only printing supports attached to the build plate, and printing this at a 90 degree angle (see photos of how I oriented Frosty Bones).
I suggest you print in white, like I did, and then paint on the black and orange.
Credits:
DippyEggs