LEGO flower post cap

LEGO flower post cap

At the moment the LEGO flower post cap is availabel for posts with a diameter of 27.5, 34.5, 42.5, 48.5 and 60.5 mm. But if none of them fits your post it is very simple to scale it. Instructions are below.

Instruction for scaling

But if none of them fits your post it is very simple to scale it. You import the postcap stem ID 100 mm for_scaling. It will look something like this:

LEGO flower post cap

Make sure that the lock for scaling is closed, as shown in the red circle above. Now you can input your post diameter in mm as the Scale factor. I recommend to add a bit tolerance. Measured: 44.2 mm → Scale factor 44.7 mm. For example for a diameter of 48.5 mm it should look like this:

LEGO flower post cap

The same has to be done with the postcap flower ID 100 mm for_scaling.

Credits:

Seemomster

Rate this 3D model

Download 3D models

File File size
zip lego-flower-post-cap-model_files 1 MB

Leave a Reply

Your email address will not be published. Required fields are marked *