Print in place blooming flower

Print in place blooming flower

Print in place flower that blooms. Model size is approx 75mm diameter x 50mm tall, opens up to 130mm diameter. Pictured model printed at 0.15mm layer height with 0.4mm nozzle on Prusa MK3 in PLA plus with standard settings. After printing, cut the small bridges between each petal around 10mm (can see the exact location in the slicer preview). Before printing, make sure bed is clean and adhesion is really good as the petals are somewhat weak until the bridge splices are printed. Printing at 0.20mm layer height may cause parts to fuse.

Credits:

Jhuttula

Rate this 3D model

Download 3D models

FileFile size
zip print-in-place-blooming-flower-model_files14 MB

Leave a Reply

Your email address will not be published.