This is a mashup between DrJones’s design “christmas tree” and my design “Ribbon Christmas tree”.
While the original model weighed only 20g this one weighs about 80g;
the spring and the star are compatible between the two models.
I recommend printing all the pieces without supports (the STL files already contain the correct positioning of the pieces to avoid supports).
INSTRUCTIONS 🧰
Stretch the spring a bit so that you can work with it better;
insert the lower end of the spring into the first hole at the base of the tree, as shown in the photo;
insert the lower end of the spring into the second hole at the base of the tree;
insert the tip of the tree into the hole at the top of the spring;
place the star on top of the spring;
enjoy! 🎄
Credits:
RAZORBACK