52mm Ringlight mount

52mm Ringlight mount 3D model

3D 52mm Ringlight mount model

52mm Ringlight mount

This is a very inexpensive and simple ring light to mount on a lens or filter with a 52mm thread. You can build two for less than $10.

Because the light itself isn’t designed for high CRI and natural color, it doesn’t render color super well but is excellent for capturing detail on small parts and is extremely portable.

The light used is;

https://www.ebay.com/itm/2X-HID-White-60mm-66-COB-LEDs-Angel-Eyes-Halo-Ring-Headlight-Fog-Housing-Lamp-US/252311720659?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

The only modification to the light is to trim off the small latch tabs on the plastic diffuser and provide a 12VDC source for the light. The included constant current driver allows a wide range of voltages and the light output remains constant – no fear of overdriving the LEDs.
The adapter can just be glued into the back of the diffuser – the wires exit through the small slot at the edge of the ring

Print Settings

Printer:

Raise 3D N2 Plus

Rafts:

Doesn’t Matter

Supports:

No

Resolution:

.1mm or less

Infill:

20%

Notes:

Thin layers are necessary to render the fine threads but they can be printed with a 0.4mm nozzle without and problem

Credits:

MDVolle

Rate this 3D model

Download 3D models

File File size
zip 52mm_Ringlight_mount 246 KB

Leave a Reply

Your email address will not be published. Required fields are marked *