Following the example set by nemokeine the holes in these have been enlarged from 3mm to 4mm for an easier time getting the 95 paracord through armourcraft’s models.
Shown pictured with 6.25″ pieces of 95 paracord tied into a loop for looping through one zipper hole and an 8.5″ piece tied in a loop for looping through two zipper holes.
Printed here in ASA, but other materials should work too.
Print Settings
Rafts: No
Supports: No
Resolution: 0.16
Infill: 0.5
Notes:
printing one at a time caused layer sagging that appeared to be from insufficient cooling time between layers. Printing ten at a time did not have that same issue.
Credits:
PenguinFeet
Download 3D models
| File | File size |
|---|---|
95-paracord-zipper-pulls-model_files
|
522 KB |