This is a 100% printable, adjustable and folding, Phone or Tablet stand. It was designed to be simple and clean looking, while being tough enough to throw into a bag or a purse. Print all three parts, snap the arm into the holes closest to the closed end of the base, and snap the phone cradle into the holes closest to the open end of the base with the ‘tusks’ up. The stand should fold down so the cradle is flush with the top of the base, with the arm surrounded by the base below the cradle. You should then be able to rotate the cradle and arm upward, notching the arm in the slots on the bottom of the cradle. The cradle should hold a phone that is 12mm thick, and the back of the cradle is approximately 5cm wide which should be hidden by a phone with 3.5″ or greater screen.
This stand should be printed in relatively hard plastic like PET or PLA, and can be scaled down by up to 33%, or scaled up, to accommodate different tablets or phones. Infill should be set to 10% or greater, and I print the at .2mm layer height.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
25%
Credits:
_Shade_
Download 3D models
| File | File size |
|---|---|
Adjustable_Folding_Phone_or_Tablet_Stand
|
882 KB |