Always misplacing my Airpods, so I designed this sleeve to hold the Airpod case and a Tile Tracker http://www.tileapp.com/
You can slide the airpod case in either way (allowing you to expose the charger port), should slide in an out fairly easily but also be snug enough to stay in.
The tile is held in place by a small nub in the key ring hole.
Fusion 360 project files are in the “How I Designed This” section.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3 MMU 2
Rafts:
No
Supports:
No
Resolution:
.15mm
Infill:
Doesn’t matter
Notes:
I used Slic3r PE with .45mm perimeters and .15mm layer heights.
How I Designed This
Airpod’s / Tile Mate with Replaceable Battery
https://a360.co/2EP3uQd
Old Tile Mate with Non Replaceable Battery
https://a360.co/2EQJRHP
Credits:
vertigo235
Why is there no charging port?