This is a basic clamp for securing the iMac base to a table. It requires two 1/4-inch screws that go into/through the table but nothing goes through the iMac base itself. It should be printed “upside down” so that you get a smooth top and a taper underneath to match the taper of the iMac base. The side walls are angled to keep the base from sliding backward and there is a hook on the front to keep the base from sliding forward. The screws are very close to the base so they do most of the holding and you don’t rely too much on the strength of the plastic.
Print Settings
Printer Brand:
MakerGear
Printer:
MakerGear M2
Rafts:
Doesn’t Matter
Supports:
No
Infill:
20%
Notes:
Be generous with the infill. This is a small part but you want some strength.
Credits:
rh700