Belt

Belt

This is a wearable, articulated, print in place, super fashionable 3d printed belt.

Please take note:

Use 4 perimeters
Before printing please make sure to print the file Testprint-2-2.stl first
If the hinges are welt together it helps to set a horizontal expansion (Cura) or XY- size compensation (Slic3r) of up to -0.1. Don’t go much smaller because it weakens the hinges.

Find your size:
The number at the end of the file name is the length of the belt in milimeters measured from the hooks to the middle (the 3rd) element with the corresponding grooves. In short: The number should be close to your hips measurement. Please measure your hips where you wear your belt. Do not convert your usual belt length because it often turns out to be to short.

Credits:

Printschnitzel.at

Rate this 3D model

Download 3D models

File File size
zip belt-22-model_files 28 MB

Leave a Reply

Your email address will not be published. Required fields are marked *