This is a Wireless Charging Stand for my Samsung S7 in an otterbox symmetry.
It should work for larger phones without a case…
I used frederico4d’s Cartoon Knight and “cut” of most of its shield.
I made a shield that fits the electronics of a disassembled IKEA wireless charger.
The Shield is in 3 pieces so it is easy to scale the thickness or the size of the shield to have it fit another charger.
You just glue on the shield at the right hight for your phone. (the cross needs to be in the middle of the phone usualy.)
Print Settings
Printer Brand:
Anet
Printer:
A6
Rafts:
No
Supports:
Yes
Resolution:
0.3 mm
Infill:
10 %
Filament: 123-3D PLA “red” on the photo it looks red but IRL it is orange like on the photo of the shield.
Notes:
I set the model at a 45 degree angle so the front of the model would be free of supportdammage.
I set support angle to 60 dgr but printing at 0.3 it might be posible to go higher.
(I should print a test to see what overhangs my A6 can do….)
Credits:
MenNoIron