I have designed this stand for wireless charger slim pad. This is not a regular samsung wireless charger but they sell it as a separate accessories.
Charger pad diameter is 88 mm and thickness is 12 mm. See the attached pics before you start printing.
No support is required if your printer can handle 65 degree overhangs. Takes about 3 hours to print at 0.2 mm layer height.
You can place charging cable through the cable routing provided in the model. If your cable is wider than the slot, then you can also keep it from either side as shown in one of the images.
Any device upto 13 mm thick can be place on the stand.
Most suitable for desk. The angle of the stand help to unlock the phone via face recognition without picking up the phone.
Print Settings
Printer:
Ender 3
Rafts:
No
Supports:
Doesn’t Matter
Resolution:
0.2
Infill:
15
Filament: Inland PLA Red
Notes:
No supports required if your printer can handle 65 degree overhangs.
Credits:
shehul1991
Download 3D models
| File | File size |
|---|---|
Charging_stand_for_SAMSUNG_wireless_slim_pad
|
61 KB |