List of changes:
I remade the mount with a smaller plate to allow me to access the battery compartment on my camera.
The original dimensions were slightly loose-fitting so I remade each part with a smaller clearance between each part.
The front legs weren’t identical so I fixed that.
I made the holes recessed to fit flush with M5 hex bolts where necessary.
Print Settings
Rafts: Doesn’t Matter
Supports: No
Resolution: 0.2
Infill: 20%
Notes:
Identical parts – print the front leg twice.
Post-Printing
You will need: – 2x M5 self-locking nuts – 3x M5 washers – 1x M5 wingnut – 2x M5 hexagonal bolts – 16 mm long – 1x M5 hexagonal bolt – 60 mm long – 1x 1/4-20 UNC bolt for the camera (or a bolt off another tripod)
Credits:
willcollin