This is a customisable rear lens cap. It was designed for a Mamiya RB67 lens cap but it also fits RZ67. All the relevant dimensions and texts can be changed in the attached .f3d file. If you don’t have fusion360 and need other dimensions you can contact me to change them.
I would be very thankful for any donations under paypal.me/uwe765.
Following files have been uploaded:
-Mamiya_CostumisableRearLensCap.f3d
the fusion360 file with parameters
-Mamiya_LensCapRear_Docum.pdf
documentation with parameters description
-Mamiya_LensCapRear_NoAsthetics.stl
lens cap for an 88mm diameter lens
-Mamiya_LensCapRear_f37mmFishEye.stl
lens cap for an 88mm diameter lens, with inscription
-Mamiya_LensCapRear_65mm_f4_5.stl
lens cap for an 88mm diameter lens, with inscription
-Mamiya_LensCapRear_90mm_f3_5.stl
lens cap for an 88mm diameter lens, with inscription
-Mamiya_LensCapRear_127mm_f3_5.stl
lens cap for an 88mm diameter lens, with inscription
-Mamiya_LensCapRear_180mm_f4_5.stl
lens cap for an 88mm diameter lens, with inscription
Printing:
–Material
I recommend a flexible filament, but PLA also works (to compensate for shrinking a
scale factor of 100.2% to 100.25% is recommended for PLA).
–Infill
Infill of 30% was used successfully
The letters sometimes losen while printing. Good adhesion is necessary for a clean base.
Everything else should be set to a standard profile.
Credits:
aerogel
Download 3D models
| File | File size |
|---|---|
Customisable+Rear+Lens+Cap+-+Mamiya
|
4 MB |