This is a battery powered ventilating face shield.
It requires:
12×12 inch plastic sheet around 6 mil
a 3 volt motor
2 sets of aaa battery contacts
a small piece of HEPA or MERV filter
1 inch strap
20 gauge wire
Soldering equipment
non stretch cotton/ polyester fabric
Print Settings
Printer brand: Creality
Printer: CR-10
Rafts: No
Supports: Yes
Resolution: 0.16
Infill: 25%
Filament_brand: Polymaker Polyflex
Filament_color: Black
Filament_material: TPU
Notes:
I used pla and I like to raise the frame_edge, cheek_brace, and port_door models off the bed 2 mm and use TOUCHING BUILDPLATE SUPPORTS.
Credits:
electricwolfpit