When our cat enters the room, she opens the door very wide. Which is not wanted to keep the bedroom dark and cool.
So I added a small piece with some 6mm magnets to the door (just clip on with some foam tape) and a magnetic counterpart on a arm to the wall.
This generates a soft stop of the door at a small gap, wide enough for our cat to enter. The door can still open and close fully.
Looks silly, but it works 🙂
Fits all on a 200mm printer bed and prints without support. (Orientate the tip in the holes upwards)
Screw all together with M4x25 screws and some nuts, insert 6mm diameter magnets (max. 4mm high – done
Credits:
Download 3D models
| File | File size |
|---|---|
Door stopper for cats
|
39 KB |