I’ve been experimenting printing in Vase Mode these days and have ‘discovered’ a better way to print in this mode (at least for me): using a 0.5mm nozzle to print 1mm thick wall.
You guys may already knew it but this is a new experience for me.
You can see the result in my photos.
It’s sturdy enough to hold my phones, my kindle, less plastic, less time printing.
Print Settings
Printer:
Modified Anet A8 & Self-built Mrk.I
Rafts:
Doesn’t Matter
Supports:
Doesn’t Matter
Resolution:
0.3
Filament: Cheap Chinese ones PLA
Notes:
Enable Spiralize Outer Contour and set Line Width to 2x your nozzle size, mine is 0.5mm so I set it to 1mm.
Credits:
hdragoon