Ok, here is a holder for Eurorack patch cables that is somewhat parametric. I am new to sharing stuff on thingiverse so hopefully this works as I assume it should. I have included the Fusion3D file, where you can change parameters for arm spacing, arm width, arm quantity and a few other things. Some values such as setting the arm width too low will make the model wonky, but after testing a few values on quantity and spacing it seems to work well enough. If there is something I need to change or improve don’t hesitate to tell me, I am quite new to parametric modelling so I am sure I have made some mistakes 🙂
The STL I have included has a 4mm spacing between arms.
You will probably get away with not printing supports for the screw holes if your printer is well calibrated.
Print Settings
Printer:
Wombot Exilis
Rafts:
No
Supports:
Doesn’t Matter
Infill:
100%
Filament: eSun PLA+ White
Credits:
stillwideawake